How To Repair Pull String On Blinds

How to Restring a Vertical Blind Headrail

Introduction

When the string on your vertical blind becomes frayed or breaks completely, information technology is necessary to restring the blind. These instructions testify how to restring your vertical bullheaded headrail. The bullheaded shown is a common vertical bullheaded with a one-way draw. The parts in your blind may wait different, but the techniques shown will utilize.

A Note on Safety

Kids can strangle in bullheaded cords. To make your blinds safer for kids, go on cords out of accomplish and secure cord and bead chain loops. To larn more, delight visit our child safety guide.

Tools Needed

Scissors

Phillips Screwdriver

Needle Nose Pliers

Lighter

Parts Needed

Step 1 – Measure the blind.

Use the post-obit formula to determine the amount of string needed:
2x the width of the blind + 2x the length of the blind + 5 ft.
Cut the length of cord needed.
Remove your slats from the blind past using a apartment object like a plastic card to release the slats from the clips.

Step two – Remove the headrail by pushing up on the bracket tabs on the behind of the blind. Place the headrail on a flat surface.

Remove any cord weight or tensioners from the blind chain or string.
Pull the string gratis from the blinds with your pliers.
Cut the ends knots off of the cord.

Step 3 – Use the lighter to melt an end of the new string to the old cord.

Whorl the cord to meld the ends together.
Pull the string through the blind.

Step iv – Tie a knot at the end of the new cord and so information technology won't pull through the blind.

Cut off the one-time string.
Tie a knot and cut any excess cord.

Step 5 – If your cord is completely missing or broken, remove the control end.

Use the wire restring tool to feed the string through the carriers and command end.

Step six – Feed your string through the eye of the wire and pull through.

Feed the string around the cycle on the idle end.

Step 7 – Feed the wire restring tool through the last carrier. Pull the cord through, and tie a knot.

Feed the wire back through the carriers and command finish.
Pull the cord through the control terminate.

Step 8 – Insert the wire through the other hole in the last carrier, and pull the cord through.

Tie a knot, and cut any excess cord.
Test your repair by pulling the cord.

Step ix – Some carriers vary on the make and may have unlike cord paths.

If the string needs to be fed through a small pigsty, melting the end of the string will prevent fraying.
Feed the cord through the carrier, and tie a knot at the end of the cord.

Step 10 – Reattach the control end.

Step xi – Reattach any string weights or tensioners to the cord and chain. It'southward important to keep all loops tied down securely for kid rubber reasons.

If necessary, adjust the length of the cord past pulling the cord through and tying a new knot.
Reattach your blind to the brackets by inserting the front of the headrail into the bracket and rotating the headrail up and back.

Step 12 – Reattach your vanes to the blind.

Step 13 – Test the repair by pulling the blind open and closed.

String Path Diagram

Source: https://fixmyblinds.com/pages/how-to-restring-a-vertical-blind-head-rail

Posted by: rascoswittleir78.blogspot.com